Furuno FCV-295 Instrukcja Użytkownika

www. furuno.c o .jpAll brand and product names are trademarks, registered trademarks or service marks of their respective holders.Installation ManualC

11. MOUNTING1.1 Display UnitMounting considerations• Locate the unit out of direct sunlight.• Select a location where the display screen can be easily

21.2 TransducerThe performance of the echo sounder depends upon the transducer position. A place least affect-ed by air bubbles should be selected sin

3Thru-hull mount water temperature sensor T-02MSB, T-03MSBSelect a suitable mounting location considering the following points:• Select a mid boat fla

4Through-hull mount water temperature/speed sensor ST-02MSB, ST02-PSBSelect a suitable mounting location considering the following:• Select a mid-boat

52. WIRING2.1 InterconnectionRefer to the interconnection diagram at the back of this manual for detailed information.Wiring diagram for FCV-295LowTra

62.2 Cable FabricationPower cableThis echo sounder is designed to be powered with 12-24 VDC. Use the cable DPYCY-1.5 (Japan Industry Standard) or equi

7WAGO connector (for transducer and NMEA ports)NMEA portConnect a GPS navigator, etc. to NMEA port J2 #1 to #4. You can connect two sensors (for ex-am

82.3 Input/Output SentencesInput sentencesOutput sentencesSentence Data RemarksBWC Range/bearing to waypointGGA Time, position GPS positionGLC GRI, Ti

93. INITIAL SETTINGThis chapter provides the information necessary for initial setup of the equipment. First turn on the power and set display languag

104. Press T or S to select necessary unit and then press the ENTER key to set.• Depth: m, ft, fa, pb, HR (Japanese unit)• Temp: °C, °F• Speed: kt, km

iWARNINGIndicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.CAUTIONIndicates a potentially haza

111. At the transducer setting screen, confirm that "XDCR Select" is set to "XDCR Type" (default setting).Transducer setting scree

126. Press T to select "Transducer" and then press the ENTER key. The list of programmed trans-ducers appears.7. Press T to S select transdu

13Entering transducer data by transducer specificationsTo connect the transducers which are not programmed, do as follows:Note: The transducers of 53

143. Press T to select "Temp" and then press the ENTER key.Temperature calibration screen4. Press T or S to set the value for the temperatur

153.4 NMEA Port SettingIf a GPS navigator and/or other sensor are connected, set up as follows.1. Press the MENU key.2. Press T to select "System

16WAAS Setup: Choose how to use the WAAS signal when connecting with a WAAS capable GPS receiver, for example GP-320B/330B. The message types (WAAS-00

AP-1APPENDIX TRANSDUCER 82B-35RThe 82B-35R is a transducer with wide bandwidth of 65 kHz-110 kHz. It is constructed to provide protection against slam

AP-2Setting for dual frequency transmitting1. Set the XDCR SELECT menu as follows (see page 11 and 12).2. Press the [PWR] key to turn the power off, a

NAME OUTLINE Q'TYDESCRIPTION/CODE №ＰＡＣＫＩＮＧ　ＬＩＳＴ02GE-X-9851 -1 FCV-295-J/E1/1NAME OUTLINE Q'TYDESCRIPTION/CODE №ユニット UNIT指示器DISPLAY UNIT1**CV

Nov.12'07 R.EsumiD-1

iiCAUTIONObserve the following compass safedistances to prevent interference to amagnetic compass:Ground the equipment toprevent mutual interference.D

Nov.12'07 R.EsumiD-2

243A1BCDRAWNCHECKEDAPPROVEDDWG.No.TITLENAME名称INTERCONNECTION DIAGRAM相互結線図カラー魚群探知機COLOR LCD SOUNDERFCV-295T.YAMASAKIT.TAKENOREF.No.SCALE MASSNOTE*1: SH

The paper used in this manualis elemental chlorine free.・FURUNO Authorized Distributor/Dealer9-52 Ashihara-cho,Nishinomiya, 662-8580, JAPANTelephone :

iiiSYSTEM CONFIGURATIONBasic configuration is shown with solid line.High Freq.Low Freq.TransducerTransducerNavigatorDisplay unitCV-29512-24 VDCRectifi

ivEQUIPMENT LISTSStandard supplyOptionName Type Code No. Qty RemarksDisplay Unit CV-295 - 1Spare Parts SP02-05501 001-032-740 1 setSee packing list at

vCombination of transducer, thru-hull pipe and tankOutput(W)Frequency(kHz)Ship type Transducer Thru-hull pipe Tank1k/1k 28/50 Steel 28F-850B-9BTWB-600

vi2k/2k28/107 Steel 28F-18100B-10RTFB-7000(2) T-636FRP TRB-1100(2) T-636-F2k/3k 28/150 Steel 28F-18150B-12HTFB-7000(2) T-637FRP TRB-1100(2) T-637-F50/

vii3k/3k 38/150 Steel 38BL-15HR150B-12HTFB-7000(2) T-683FRP TRB-1100(2) T-683-F38/200 Steel 38BL-15HR200B-12HTFB-7000(2) T-683FRP TRB-1100(2) T-683-F5

viii2k38 Steel 38BL-9HR TFB-5000(1) T-702FRP TRB-1000(1) T-702-F50 Steel 50B-12 TFB-5000(1) T-611FRP TRB-1000(1) T-611-FSteel 50BL-12 TFB-5000(1) T-70